Oce CS193 - Auto Tray Switch Feature; Order for Selecting Paper Trays

7
Copy paper/originals
7-6 CS193/CS173/CS163
7.1.6 Auto tray switch feature
If the selected paper tray runs out of paper while a job is being printed and a different paper tray is loaded
with paper meeting the following conditions, the other paper tray is automatically selected so printing can
continue. If the optional LCT is installed, a maximum of 3,650 copies (with A4 v paper) can be made
continuously. (The paper tray is automatically switched only if the "Auto Tray Switch ON/OFF" parameter in
the Utility mode is set to "Allow".)
Operating conditions
- The paper is the same size.
- The paper is positioned in the same orientation.
- The paper is the same type.
- The paper trays are selected when the paper tray is automatically switched.
!
Detail
For details on the specifying the paper trays that are selected when the paper tray is automatically
switched, refer to "System Settings" on page 12-23.
7.1.7 Order for selecting paper trays
As a factory default, when a different paper tray is automatically selected, the next paper tray in the following
list is chosen.
Tray 1 % Tray 2 % Tray 3
*1
% Tray 4
*1
% LCT
*2
% Bypass tray
*1
Appears only when the optional paper feed cabinet is installed.
*2
Appears only when the optional LCT is installed.
!
Detail
To change the order in which the paper trays are selected, refer to "System Settings" on page 12-23.