8
Application functions
8-76 CS193/CS173/CS163
– To cancel the "Frame Erase" function, touch [No].
?
What happens when [Frame] is selected?
% The same width is erased on all four sides of the original. The factory default setting is "Frame".
?
Can the settings be combined?
% "Frame" cannot be combined with the other settings ("Top", "Left", "Right" or "Bottom").
4 Touch [-], [+] or [None] to specify the width to be erased.
– To specify a different width to be erased depending on the position, specify different settings for
"Top", "Left", "Right", and "Bottom".
– When using the keypad to specify the settings, press the [C] (clear) key to erase the value, and then
type in the setting.
?
What happens when a value outside of the allowable range is specified?
% The message "Input error" appears. If "Input error" appears or if the erased width was incorrectly
entered, press the [C] (clear) key in the keypad, and then specify the correct value.
5 Touch [OK].
6 Specify any other desired copy settings.
7 Using the keypad, type in the desired number of copies.
8 Press the [Start] key.
To Next Page
Loading...
