4535 612 10261 HD11 Service Manual Page 46
CSIP Level 1 System Specifications: System PC Specifications
Serial Port One required on motherboard, set up as COM1
and one as additional PCI card.
Mouse and Keyboard None desired—will use custom devices
Mini Tower Case Custom Philips case. Case will have a power
button on the rear of the chassis that is in parallel
with power button on the control panel. The case
shall also provide an LED mounting location on
the front of the chassis that allows the Hard Disk
Drive active LED to be visible from the front of
the machine.
Front accessible drive bays Three 5.25 in
One 3.5 in
Internal drive bays One 3.5in
IDE cables Primary IDE cable must support UDMA 66, ATA/
100 or Primary cable may be Serial ATA
Secondary IDE cable must be able to
simultaneously connect to drives whose keyway is
up (missing pin down) in the top and bottom bays.
HDD LED Cable Custom Philips cable mounted T1 yellow LED
connects to HDD LED pins on front panel header
on motherboard
Table 2-1 PC Hardware Specifications (Continued)
Component Description
To Next Page
Loading...