Chapter 8: Troubleshooting
325
Fibre Channel
Fibre Channel controller
has detected bus reset
The initiator sent a reset command. If this message
appears repeatedly, contact Technical Support. See
page 355.
Fibre Channel controller
has received a LUN reset
command.
Result of user action. Normal.
Fibre Channel controller
has encountered a fatal
error
Restart the VTrak. See page 119 or page 245. If this
message appears repeatedly, contact Technical
Support. See page 355.
Fibre Channel link is up FC link connected and ready. Normal.
Fibre Channel link is
down
FC link disconnected or otherwise not working.
Fibre Channel controller
settings have changed
Result of user action. Normal.
Host Interface Controller
Host-interface controller
has detected bus reset
The initiator sent a reset command. If this message
appears repeatedly, contact Technical Support. See
page 355.
Host-interface controller
has encountered an
unrecoverable error
Restart the VTrak. See page 119 or page 245.
Host-interface controller
has received an abort-
task/ abort task set/clear
task set command.
Result of user action. Normal.
Host-interface controller
has received an clear
ACA command.
Result of clearing an auto contingent alliance
condition. If this message appears repeatedly,
contact Technical Support. See page 355.
Host-interface controller
has received a LUN reset
command.
Result of user action. Normal.
Host-interface controller
has received a bus reboot
The VTrak rebooted itself. If this message appears
repeatedly, contact Technical Support. See page 355.
Host-interface controller
has encountered an
unknown error
An unidentified error occurred. If this message
appears repeatedly, contact Technical Support. See
page 355.
Reported Event Corrective Action