● Case 2: Acceptance test of a machine or installation with the installed drive
systems.
The product standard for the respective type of machine/installation, if exist-
ing, applies to the acceptance test of the machine or installation. In the last
years, some new product standards were created at present.
These new product standards contain references to the product standard
EN 61800-3 for drives or specify higher-level requirements demanding increased
filter and installation efforts. When the machine manufacturer wants to put the
machine/installation into circulation, the product standard relevant to his ma-
chine/ installation has to be complied with for his end product “machine/instal-
lation”. The authorities and test laboratories responsible for EMC normally refer
to this product standard.
This documentation specifies the EMC properties which can be achieved, in a
machine or installation, with a drive system consisting of the standard compo-
nents.
It also specifies the conditions under which the indicated EMC properties can
be achieved.
EFC x610 Series Bosch Rexroth AG
Electromagnetic Compatibility (EMC)
DOK-RCON03-EFC-X610***-IT05-EN-P
73/389
To Next Page
Loading...
