3.Appendices: SP Mode Tables
167
If this bit switch, all jobs will be cancelled after a jam occurs.
Note: If this bitsw is enabled, printing under the following conditions might result in problems:
- Job submission via USB or Parallel Port
- Spool printing (WIM >Configuration > Device Settings > System)
Timing of the PJL Status ReadBack (JOB END) when printing
multiple collated copies.
This switch determines the timing of the PJL USTATUS JOB END sent when multiple collated copies are
being printed.
0 (default): JOB END is sent by the device to the client after the first copy has completed printing. This
causes the page counter to be incremented after the first copy and then again at the end of the job.
1: JOB END is sent by the device to the client after the last copy has finished printing. This causes the
page counter to be incremented at the end of each job.
Display UTF-8 text in the operation panel
Text composed of UTF-8 characters can be displayed in the operation panel.
Disabled (=1):
UTF-8 characters cannot be displayed in the operation panel.
For example, job names are sometimes stored in the MIB using UTF-8 encoded characters. When
these are displayed on the operation panel, they will be garbled unless this switch is enabled (=0).
Switches super option disable on / off.
If this is On, multiple jobs are grouped at LPR port. PJL settings are enabled even jobs that are specified
queue names are sent.
Enable/Disable Print from USB/SD's Preview function
Determines whether Print from USB/SD will have the Preview function.
Enabled (=0): Print from USB/SD will have the Preview function.
Disabled (=1): Print from USB/SD will not have the Preview function.
To Next Page
Loading...
Need help?
General
