Ricoh M0A0 - Page 675

4.Service Tables
49
the oldest communication records.
 This setting is effective only when Automatic Journal printout is
enabled but the machine cannot print the report (e.g., no
paper).
1*
Action when the SAF memory has
become full during scanning
0: The current page is erased.
1: The entire file is erased.
0: If the SAF memory becomes full during scanning for a memory
transmission, the successfully scanned pages are transmitted.
1: If the SAF memory becomes full during scanning for a memory
transmission, the file is erased and no pages are transmitted.
 This setting is effective only when Automatic Journal printout is
enabled but the machine cannot print the report (e.g., no
paper).
2
RTI/CSI display priority
0: RTI 1: CSI
This bit determines which identifier, RTI or CSI, is displayed on the LCD
while the machine is communicating in G3 non-standard mode.
3
File No. printing
0: Enabled
1: Disabled
1: File numbers are not printed on any reports.
NOTE: The file numbers may not be printed in the sequential order. If a
customer does not like this numbering, select "0".
4
Action when authorized reception
is enabled but authorized
RTIs/CSIs are not yet
programmed
0: All fax reception is disabled
1: Faxes can be received if the
sender has an RTI or CSI
0: If the user has stored no acceptable sender RTIs or CSIs, the user can
select “ON” in the authorized reception setting but the setting becomes
invalid (“OFF”). The machine will not be able to receive any fax
messages.
If the customer wishes to receive messages from any sender that includes
an RTI or CSI, and to block messages from senders that do not include an
RTI or CSI, change this bit to "0", then enable Authorized Reception.
Otherwise, keep this bit at "1 (default setting)".
5-
7
Not used
Do not change the settings
* This setting can be used for the client machine which has no FCU.
System Switch 1F (SP No. 1-101-032)
No
Function
Comments
0
Not used
Do not change the settings.
1
Report printout after an original jam during
SAF storage or if the SAF memory fills up
0: Enabled
1: Disabled
0: When an original jams, or the SAF memory overflows during
scanning, a report will be printed.
Change this bit to "1" if the customer does not want to have a
report in these cases.
Memory TX – Memory storage report
Parallel memory TX – Transmission result report