Operation
Operating modes "Turtle" and "Rabbit"
6.8 Operating modes "Turtle" and "Rabbit"
The icon ("Turtle"/"Rabbit") of the currently active operating mode is displayed on the
R-Touch.
The machine can be operated in the following modes:
"Turtle I" = Loading operation
"Turtle II" = While it is possible to switch into this operating
mode, in practice, however, it does not make any
sense because this would switch off the all-wheel
drive.
"Rabbit I" = Slow driving on roads with all-wheel drive
"Rabbit II" = Rapid driving on roads without all-wheel drive
ATTENTION
Hazard of severe damage to traction drive!
In the "Rabbit" operating mode, particularly when driving downhill,
in the variant 1 with one traction drive motor, never exceed 35 km/h
in the variant 2 with two traction drive motors, never exceed 43 km/h.
– Adjust your way of driving
– Drive on steep slopes downhill at reduced speed
– Slow down in emergency cases the vehicle using the operating brake
184 / 546
To Next Page
Loading...