ROPA Maus 6 - Product Data Sheet ROPA Multi Temperature Grease 2

Lists/Tables/Plans/Diagrams/Maintenance Verification
Lubricant specification table
9.4.7 Product Data Sheet ROPA multi temperature grease 2
Properties
ROPA multi temperature grease 2 is an EP grease based on resistant to ageing mineral oils.
It especially meets the requirements of BEKA-MAX central lubrication systems and is suitable for the lubrica-
tion of roller and sliding bearings, even under high loads. ROPA multi temperature grease 2 can also be used
without problems for lubrication points that require grease as per MAN standards (works standard MAN 283
Li-P2) and Mercedes- Benz (delivery specification: DBL 6804.00 - Fuel regulation sheet 267).
Information on use
Wheel bearing lubrication of trucks, construction machines, industrial trucks and agricultural machines. Lubri-
cation of the slewing ring bearings. Bearing lubrication of machine tools, presses, pumps, electric motors.
For central lubrication systems of agricultural and construction machines.
Special advantages:
easy to pump in central lubrication systems resistant to ageing
water-resistant mechanically very stable
corrosion-proof high pressure absorption capacity
strongly adherent
Description / specifications as per DIN 51 502, KP 2 K-30
Approvals Beka-MAX central lubrication systems
Usage recommenda-
tions
MAN (works standard MAN 283 Li-
P2)
Mercedes-Benz (Fuel regulation sheet 267)
Ropa item no. & container sizes See Page 508
Characteristics as per DIN 51502 KP 2 K-30
Thickener Lithium soap
Operational temperature range from -30 to +120 °C
Permissible for short term +130 °C
Dropping point DIN ISO 2176 approx. 175 °C
Worked penetration after 60 DH (double cycles) DIN ISO 2337 from 265 to 295 1/10 mm
Penetration in waste after 100,000 DH < 30 1/10 mm
Base oil type Mineral oil
Base oil, viscosity at 40°C DIN 51562-01 110 mm²/s
Water resistance DIN 51807-01 1 – 90
Emcor test DIN 51802 Corrosion degree 0
Corrosion effect on copper DIN 51811 Corrosion degree 1 - 100
Mechanical dynamic test FAG-FE9 DIN 51821-02
-A/1500/6000-120
F
50
>100h
VKA-welding power DIN 51350-04 2400 N
All characteristic data are subject to production-related variations. We reserve the right to make
modifications to the technical data. For more information, see our Material Safety Data Sheet.
515 / 546