Operation
Scales (option)
Once the correct calibration value has been determined, the calibration value can
also be refined using the deviation of the amount per week (only if the scales are
operated in a consistent manner and the loading conditions are reasonably similar).
6.16.2.8 Continuing operation of scales
Follow the directions in Page 298.
Perform zeroing at regular intervals.
Check the accuracy of the scales regularly. Compare the weight of a load displayed
by the scales with the weight recorded externally on the calibrated scale of the con-
signee. Calibrate the scales immediately should any large deviations occur.
ADVICE
The weighing accuracy depends on the attention of the user. Regular zeroing, care-
ful calibration and as little soil accumulation on the conveyor will ensure continuing
weighing accuracy.
6.16.2.9 Scale wizard interface (option)
Optionally, the machine can be equipped with an interface for data transfer from the
scales.
Südzucker AG's TMS device processes the data from the scales and lists the weight
of each loading of the Maus. After the truck has been weighed on the factory scales,
it shows you on the TMS device the weight of the loading determined there and the
deviation from the weighing result of the Maus.
Thus, you always have an automated overview of the actual accuracy of the scales
and can react accordingly.
310 / 546
To Next Page
Loading...