ROPA Maus 6 - Installing and Adjusting the Bearings of the Pinch Rollers or Conveyor Rollers; Replacing Radial Shaft Seals (Simmer Rings) on the Gearbox

Maintenance and Service
Pickup
7.8.4.5 Installing and adjusting the bearings of the pinch rollers or
conveyor rollers
A special tool is essential for installing or adjusting the bearings (adjustable taper
roller bearings) at the ends of the pinch rollers and conveyor rollers. This tool can
be ordered under the ROPA item no. 018002400. However, this work is very rarely
required and can only be performed by experienced technicians.
7.8.4.6 Replacing radial shaft seals (Simmer rings) on the gearbox
Because the pickup roller bearings are exposed to a large amount of dirt due to their
design, soil may penetrate the gearbox flange over time in spite of thorough seal-
ing. For this reason the two radial shaft seals (ROPA item no. 246002800) (31),
the two inner rings (ROPA item no. 240015200) (32) and the two felt rings (ROPA
item no. 246002600 (33) and ROPA item no. 246014500) (34) on the gearbox side
bearing of the pickup roller must be replaced after approx. 300,000 t loading for safety
reasons.
Remove the gear sleeve (8), the dirt deflector flange (35) and the bearing flange (36)
for this purpose.
Removing the gear sleeve (8) requires the ROPA special tool item no. 018068000.
Remove dirt deposits on the inner saw-tooth thread in the dirt deflector flange (35).
During reassembly always replace the O-rings (37) (ROPA item no. 412081000) and
(38) (ROPA item no. 412081000) at the same time.
36
31
35
37
8
32
4
36
35
8
33 34
38
405 / 546