Maintenance and Service
Truck conveyor
Check the gap between the weighing frame and the truck conveyor articulation
frame
The distance (8) must be the same on both sides. If necessary, change the dimension
by adjusting the diagonal brace in the weighing frame (9).
7.12.2.2 Remove dirt accumulated on the scales
Remove the dirt that builds up between the weighing frame and the side walls on
a regular basis. Make sure that the weighing frame is not subjected to any external
forces; it may only be exposed to loads caused by the mass of the sieve conveyor and
the load on top of it.
The inclined position of the support rollers on the truck conveyor articulated section
creates a self-cleaning effect, but it is not always sufficient. Therefore, regularly check
whether the support rollers on the weighing frame as well as the support rollers in front
of and behind the weighing frame are dirty. It might be necessary to clean it several
times a day depending on the soil characteristics.
420 / 546
To Next Page
Loading...