Operation
Loading operation
6.14.10 4-part pinch rollers in the pickup (drive D)
(See Page 256)
The 4-part pinch rollers in the pickup move the beets to the center of the pickup onto
the infeed conveyor. They only move in the feed direction when the machine drive is
switched on and the infeed conveyor is running.
These pinch rollers may also be reversed when the infeed conveyor stops.
To switch on the 4-part pinch rollers, briefly press
the key (8) once on the right joystick.
If this key is briefly pressed again, the 4-part pinch
rollers stop.
If this key is pressed and held pressed, then the
rotating direction of the 4-part pinch rollers is
reversed.
268 / 546
To Next Page
Loading...