Operation
Loading operation
6.14.7.1 Truck conveyor fast motion
Sometimes, a larger quantity of soil sticks to the conveyor, e.g. when loading under
unfavourable conditions. To be able to fling this soil off the conveyor, the truck con-
veyor is equipped with a quick motion switch.
You can switch on quick motion using the toggle switch (33). For this purpose, move
this switch to the right and hold it for so long, until soiling is removed. The truck con-
veyor then runs at double speed.
Only switch on quick motion when the conveyor is empty and there are no more beets
on the truck conveyor. The infeed conveyor is automatically stopped for as long as the
truck conveyor belt is switched to quick motion.
6.14.8 Recleaner (drive B)
(See Page 256)
Depending on equipment, your machine has a sieve conveyor cleaner, an 8-set pinch
roller cleaner or a stone remover. They perform recleaning of the beets. The recleaner
is located between the infeed conveyor and the truck conveyor. The recleaner drive is
only operating when the machine drive has already been switched on.
Briefly press the key (9) on the right joystick once to switch on the recleaner.
If this key is pressed briefly again, then the drive for the recleaner is switched off. If
this key is pressed and held pressed, then the rotating direction of the recleaner is
reversed. Reversing of the recleaner is only possible for the versions with a pinch roller
cleaner and stone remover.
260 / 546
To Next Page
Loading...