ROVEMA CMK - PLS (Programmable Limit Switch) Compensation Parameters

Rovema CMK Operator’s Manual
Section 5: Operator Controls
200246 CMK Operators Manual (02/06/2006) 5-39
HMI (Human-Machine-Interface)
PLS (Programmable Limit Switch) Compensation Parameters
PLS Config Parameters
Parameter Description
Product Detect Compensation This is time amount of time required to adjust this position to
adjust for the delay in the solenoid valves reaction time.
Carton Release Compensation This is time amount of time required to adjust this position to
adjust for the delay in the solenoid valves reaction time.
Flap Lifter Compensation This is time amount of time required to adjust this position to
adjust for the delay in the solenoid valves reaction time.
Load Enable Compensation This is time amount of time required to adjust this position to
adjust for the delay in the solenoid valves reaction time.
Load Jam Reset Compensation This is time amount of time required to adjust this position to
adjust for the delay in the solenoid valves reaction time.
Open Flap Detect Comp. This is time amount of time required to adjust this position to
adjust for the delay in the solenoid valves reaction time.
Laser Printer Compensation This is time amount of time required to adjust this position to
adjust for the delay in the solenoid valves reaction time.
Leaflet Feed Compensation This is time amount of time required to adjust this position to
adjust for the delay in the solenoid valves reaction time.
Glue Timing Compensation This is time amount of time required to adjust this position to
adjust for the delay in the solenoid valves reaction time.
Figure 5.45
Shows the PLS Config descriptions