Rovema ULF Operator’s Manual
Section 2: Safety Instructions
200246 CMK Operators Manual (02/06/2006) 2-5
Safety Devices
Properly trained and instructed specialists must test all
technical devices, especially safety devices:
• Before commissioning
• After alterations or modifications
• After repairs
The machine must only be allowed to operate if all safety
devices (guards, locks switches etc.) are in place and fully
operational.
Safety devices must not be bypassed or otherwise made
ineffective.
Only properly trained specialists must perform maintenance
and repair work on safety devices and electrical equipment.
Any defective technical devices, especially safety devices
must be replaced immediately.
Before starting the production, the operator must perform a
daily check to ensure that all safety devices are functioning
correctly.
The user must ensure that all safety devices are examined by
a qualified specialist (e.g. by the safety inspector) at regular
intervals. Under no circumstances shall such intervals exceed
one year!
To Next Page
Loading...
