Rovema ULF Operator’s Manual
Section 2: Safety Instructions
200246 CMK Operators Manual (02/06/2006) 2-8
Safety Devices
EMERGENCY STOP Push-Button
The EMERGENCY STOP push-button causes the machine to
immediately stop operating if pushed. This push-button should
be used when there is perceived or actual damage occurring to
the machine or to an operator.
The EMERGENCY STOP button is placed on the operator's control panel of the
machine and at locations around the perimeter of the machine.
As soon as an EMERGENCY STOP switch is pressed, the machine stops, high-
power to all drives will be interrupted, and the air pressure is dropped.
Figure 2.3
Shows the EMERGENCY STOP push-button on a typical operator control panel.
To Next Page
Loading...
