ROVEMA CMK - Warning Messages

Rovema CMK Operator’s Manual
Section 9: Troubleshooting
200246 CMK Operators Manual (02/06/2006) 9-13
Warning Messages
Message Possible Cause(s) Possible Solution(s)
Warning - Alarm
Condition Bagger 1
There is an alarm condition on
the indicated bagger causing it
to stop production.
Refer to the HMI touchscreen of
the bagger to determine the
reason for the alarm. Refer to the
operator’s manual for the bagger.
Clear the fault, then press the
MACHINE READY push-button to
reset the machine.
Warning - Alarm
Condition Bagger 2
There is an alarm condition on
the indicated bagger causing it
to stop production.
Refer to the HMI touchscreen of
the bagger to determine the
reason for the alarm. Refer to the
operator’s manual for the bagger.
Clear the fault, then press the
MACHINE READY push-button to
reset the machine.
Warning - Alarm
Condition Bagger 3
There is an alarm condition on
the indicated bagger causing it
to stop production.
Refer to the HMI touchscreen of
the bagger to determine the
reason for the alarm. Refer to the
operator’s manual for the bagger.
Clear the fault, then press the
MACHINE READY push-button to
reset the machine.
Warning - Alarm
Condition Bagger 4
There is an alarm condition on
the indicated bagger causing it
to stop production.
Refer to the HMI touchscreen of
the bagger to determine the
reason for the alarm. Refer to the
operator’s manual for the bagger.
Clear the fault, then press the
MACHINE READY push-button to
reset the machine.
Warning - Alarm
Condition Bagger 5
There is an alarm condition on
the indicated bagger causing it
to stop production.
Refer to the HMI touchscreen of
the bagger to determine the
reason for the alarm. Refer to the
operator’s manual for the bagger.
Clear the fault, then press the
MACHINE READY push-button to
reset the machine.
Warning - Alarm
Condition USP
Casepacker
There is an alarm condition on
the USP casepacker causing it
to stop production.
Refer to the HMI touchscreen of
the casepacker to determine the
reason for the alarm. Refer to the
operator’s manual for the
casepacker. Clear the fault, then
press the MACHINE READY
push-button to reset the machine.
Warning-Bag
Transfer 1 Axis
Home Failed
The prox signal was not seen by
the drive during the homing
sequence.
Refer to the drawing and check
the home prox wiring, including
the 24v source voltage to the
drive.