ROVEMA CMK - Page 207

Rovema CMK Operator’s Manual
Section 9: Troubleshooting
200246 CMK Operators Manual (02/06/2006) 9-14
Warning Messages
Message Possible Cause(s) Possible Solution(s)
Warning-Bag
Transfer 1 Product
Too Close or Jam
The sensor in the transfer
station has determined that
packages are either too close
together or that the packages
have jammed in the transfer
station.
Verify that the mechanical
adjustments in the transfer station
are set correctly. Determine if the
bagger is running too fast or too
slow. Determine if the infeed
conveyor is running too slow or
too fast. Verify that the infeed
conveyor is in the correct position.
Warning-Bag
Transfer 2 Axis
Home Failed
The prox signal was not seen by
the drive during the homing
sequence.
Refer to the drawing and check
the home prox wiring, including
the 24v source voltage to the
drive.
Warning-Bag
Transfer 2 Product
Too Close or Jam
The sensor in the transfer
station has determined that
packages are either too close
together or that the packages
have jammed in the transfer
station.
Verify that the mechanical
adjustments in the transfer station
are set correctly. Determine if the
bagger is running too fast or too
slow. Determine if the infeed
conveyor is running too slow or
too fast. Verify that the infeed
conveyor is in the correct position.
Warning-Bag
Transfer 3 Axis
Home Failed
The prox signal was not seen by
the drive during the homing
sequence.
Refer to the drawing and check
the home prox wiring, including
the 24v source voltage to the
drive.
Warning-Bag
Transfer 3 Product
Too Close or Jam
The sensor in the transfer
station has determined that
packages are either too close
together or that the packages
have jammed in the transfer
station.
Verify that the mechanical
adjustments in the transfer station
are set correctly. Determine if the
bagger is running too fast or too
slow. Determine if the infeed
conveyor is running too slow or
too fast. Verify that the infeed
conveyor is in the correct position.
Warning-Bag
Transfer 4 Axis
Home Failed
The prox signal was not seen by
the drive during the homing
sequence.
Refer to the drawing and check
the home prox wiring, including
the 24v source voltage to the
drive.
Warning-Bag
Transfer 4 Product
Too Close or Jam
The sensor in the transfer
station has determined that
packages are either too close
together or that the packages
have jammed in the transfer
station.
Verify that the mechanical
adjustments in the transfer station
are set correctly. Determine if the
bagger is running too fast or too
slow. Determine if the infeed
conveyor is running too slow or
too fast. Verify that the infeed
conveyor is in the correct position.