Sailor 100 - Page 17

List of figures
98-137654-A xv
Figure 6-33: Examples of LNB LO frequencies used worldwide ...............................................6-42
Figure 6-34: Control Panel — Selecting a satellite profile ........................................................6-43
Figure 6-35: Control Panel, active events................................................................................6-44
Figure 6-36: Display (example) and keypad of the ACU...........................................................6-45
Figure 6-37: ACU menu tree ...................................................................................................6-46
Figure 6-38: Reset the system................................................................................................ 6-50
Figure 8-1: Web interface: HELPDESK .................................................................................... 8-2
Figure 8-2: Web interface: HELPDESK, Event list .................................................................... 8-3
Figure 8-3: LAN connector used for configuring the SAILOR 100 Satellite TV .......................... 8-5
Figure 8-4: Verifying software update.................................................................................... 8-7
Figure 8-5: LEDs on the ACU.................................................................................................. 8-9
Figure 8-6: ADU modules and motor stop switch ...................................................................8-11
Figure 8-7: Service switch..................................................................................................... 8-15
Figure 8-8: Above Deck Unit modules (continued) ................................................................ 8-16
Figure 8-9: GPS module........................................................................................................ 8-17
Figure 8-10: Switch off the power to the antenna ................................................................... 8-18
Figure 8-11: GPS module facing the service hatch .................................................................. 8-18
Figure 8-12: Connector for GPS PCB ....................................................................................... 8-19
Figure 8-13: Screws on GPS module....................................................................................... 8-19
Figure 8-14: Television Interface Module (TIM)...................................................................... 8-20
Figure 8-15: Switch off the power to the antenna .................................................................. 8-20
Figure 8-16: Replacing the TIM — remove the F-connector ..................................................... 8-21
Figure 8-17: Replacing the TIM — remove N, F, SMA and SUB-D connectors .......................... 8-21
Figure 8-18: Replacing the TIM — remove 4x4 Allen screws (thread size M5)..........................8-22
Figure 8-19: DC-Motor Driver Module (DDM) for Cross Elevation ............................................8-23
Figure 8-20: Location of the Cross Elevation DDM...................................................................8-24
Figure 8-21: Replacing the DDM — remove connectors ..........................................................8-24
Figure 8-22: Location of the Elevation DDM ............................................................................8-25
Figure 8-23: Elevation DDM, connectors .................................................................................8-26
Figure 8-24: location of the Azimuth DDM ..............................................................................8-27
Figure 8-25: Azimuth DDM, connectors ..................................................................................8-27
Figure 8-26: Location of the Polarisation Motor Module (PMM)............................................. 8-28
Figure 8-27: Removing the Polarisation Motor Module.......................................................... 8-29
Figure 8-28: Polarisation Motor Module, remove screws ....................................................... 8-29
Figure 8-29: Location of the PCM........................................................................................... 8-30
Figure 8-30: Removing the PCM — connectors ....................................................................... 8-31
Figure 8-31: Motors and encoders..........................................................................................8-32
SAILOR100TM.book Page xv Tuesday, January 29, 2013 2:44 PM