Sailor 100 - Page 18

List of figures
xvi 98-137654-A
Figure 8-32: Location of the Elevation Motor & Encoder .........................................................8-33
Figure 8-33: Removing the elevation drive belt ...................................................................... 8-33
Figure 8-34: Elevation DDM, disconnect 2 connectors ............................................................8-34
Figure 8-35: Attach belt .........................................................................................................8-35
Figure 8-36: Azimuth motor, remove cover.............................................................................8-36
Figure 8-37: Azimuth motor, loosen the belt tensioner...........................................................8-36
Figure 8-38: Azimuth motor, adjust belt tension..................................................................... 8-37
Figure 8-39: Azimuth DDM, disconnect connector .................................................................. 8-37
Figure 8-40: Azimuth motor, loosen the screws for the motor assembly .................................8-38
Figure 8-41: Azimuth motor, tighten the screws for the motor assembly ................................8-39
Figure 8-42: Azimuth motor, adjust belt tension.....................................................................8-39
Figure 8-43: Azimuth motor, tighten the belt tensioner ..........................................................8-40
Figure 8-44: Azimuth encoder, remove cover ..........................................................................8-41
Figure 8-45: Azimuth DDM, disconnect connector ...................................................................8-41
Figure 8-46: Azimuth encoder, remove .................................................................................. 8-42
Figure 8-47: Azimuth encoder, adjust belt tension .................................................................8-42
Figure 8-48: Azimuth Encoder, adjust belt tension ................................................................. 8-43
Figure 8-49: Azimuth motor, tighten the belt tensioner ..........................................................8-43
Figure 8-50: Replacement of X-Elevation Motor & Encoder 1................................................. 8-44
Figure 8-51: X-Elevation Motor & Encoder — belt tension/adjustment screw ..........................8-45
Figure 8-52: Cross Elevation motor assembly, 4 Allen screws .................................................8-45
Figure 8-53: Cross Elevation motor assembly, do not tighten screws ......................................8-46
Figure 8-54: X-Elevation Motor & Encoder — belt tension/adjustment screw ..........................8-46
Figure 8-55: Cross Elevation motor assembly, tighten screws................................................. 8-47
Figure 8-56: Polarisation Motor — disconnecting power.........................................................8-48
Figure 8-57: Polarisation Motor — slide off the belt ................................................................8-49
Figure 8-58: Polarisation Motor, removing 4x4 Allen screws (thread size M5) ........................8-49
Figure 8-59: Location of the X Elevation Drive Belt..................................................................8-51
Figure 8-60: Removing the cable drum ..................................................................................8-52
Figure 8-61: Location of the Elevation Drive Belt ....................................................................8-53
Figure 8-62: Elevation Drive Belt............................................................................................8-53
Figure 8-63: Elevation Drive Belt — removal ...........................................................................8-54
Figure 8-64: Elevation Drive Belt............................................................................................8-54
Figure 8-65: Azimuth drive modules, remove cover................................................................8-56
Figure 8-66: Azimuth drive belt, loosen the belt tensioner .....................................................8-56
Figure 8-67: Azimuth drive belt, adjust belt tension ............................................................... 8-57
Figure 8-68: Getting access to the azimuth drive wheel..........................................................8-57
SAILOR100TM.book Page xvi Tuesday, January 29, 2013 2:44 PM