Sailor 100 - Page 19

List of figures
98-137654-A xvii
Figure 8-69: Azimuth Drive Belt............................................................................................. 8-58
Figure 8-70: Polarisation motor — disconnect power ............................................................. 8-59
Figure 8-71: Polarisation belt — slide off 1/2 .......................................................................... 8-59
Figure 8-72: Polarisation belt — slide off 2/2.......................................................................... 8-60
Figure 8-73: ......................................................................................................................... 8-60
Figure 8-74: Location of the Zero Reference Modules (ZRM) .................................................. 8-61
Figure 8-75: Zero Reference Module (ZRM)............................................................................ 8-61
Figure 8-76: X Elevation ZRM, disconnect connector ..............................................................8-63
Figure 8-77: X Elevation ZRM, slide out..................................................................................8-63
Figure 8-78: Elevation ZRM, disconnect connector .................................................................8-64
Figure 8-79: Elevation ZRM, remove screws .......................................................................... 8-65
Figure 8-80: Azimuth ZRM, remove cover.............................................................................. 8-66
Figure 8-81: Azimuth ZRM, disconnect connector.................................................................. 8-66
Figure 8-82: Azimuth ZRM, disconnect connector...................................................................8-67
Figure 8-83: Location of the Inertial Sensor Module (ISM)......................................................8-67
Figure 8-84: Inertial Sensor Module (ISM)............................................................................. 8-68
Figure 8-85: Removing the ISM ............................................................................................. 8-69
Figure 8-86: Removing the ISM Sub D connectors ................................................................. 8-69
Figure 8-87: Low Noise Block (LNB)........................................................................................8-70
Figure 8-88: Location of the LNB ............................................................................................ 8-71
Figure 8-89: Polarisation Motor — disconnecting power ......................................................... 8-71
Figure 8-90: Removing the LNB — disconnecting the cable .....................................................8-72
Figure 8-91: Removing the LNB — loosening screws ...............................................................8-72
Figure 8-92: Removing the LNB..............................................................................................8-72
Figure 8-93: Separate the belt wheel......................................................................................8-73
Figure 8-94: Removing the LNB — position of the wheel .........................................................8-73
Figure 8-95: Removing the LNB — LNB alone..........................................................................8-73
Figure 8-96: Rotary joint.........................................................................................................8-74
Figure 8-97: Azimuth motor, remove cover .............................................................................8-75
Figure 8-98: Getting access to the azimuth drive wheel ..........................................................8-76
Figure 8-99: Rotary joint (in place).........................................................................................8-76
Figure 8-100: Rotary joint (removed)........................................................................................8-77
Figure 8-101: Updating TIM/PCM calibration data (example) ...................................................8-78
Figure 8-102: XIM data, warning..............................................................................................8-78
Figure 8-103: XIM data not ready.............................................................................................8-78
Figure 8-104: XIM data valid ....................................................................................................8-79
Figure A-1: Outline drawing: ADU.......................................................................................... A-5
SAILOR100TM.book Page xvii Tuesday, January 29, 2013 2:44 PM