Setting Batch Print Settings in Media Startup (When Using Only One Type of Media)
136
Setting Batch Print Settings in Media Startup (When Using Only One
Type of Media)
Follow the on-screen instructions to do batch settings for the print settings that are appropriate for the
type of media you are using, and then you can apply them to the product. Use this function if you are
using only one type of media.
• If you are using multiple types of media, first use [Tools] > [Media Profiles Editing] >
[Media Profiles Registration] to register a profile for each media. After that, apply the
profile for the media you are using to the product.
The items that can be set are as follows: The results of executing Media Startup are reflected in each
of the setting items.
• [Printing] > [Media Type]
• [Printing] > [Printing Mode]
• [Printing] > [Speed]
• [Printing] > [Sensor Type]
• [Printing] > [Darkness]
• Setting items under [Printing] > [Advanced] > [Calibrate]
• Setting items under [Printing] > [Advanced] > [Label Waste Prevention]
• [Interface] > [RFID] > [RFID Tag Model] > [Load] (RFID models only)
1. Tap [SETTINGS] on the Home screen or Offline screen.
2. Input the password if it is enabled.
3. Tap [Tools].
You can switch the screen by tapping / or sliding the screen to the left or right.
To Next Page
Loading...
