SATO CT4-LX User Manual

99
Configuring the Interface Settings
Interface Setting Methods
Configure the interface settings of the product according to the communication conditions of the
connected network and computer.
You can set the interface settings of the product doing either of the following.
• Set from the Settings mode of the product
• Set using the All-In-One Tool from the computer
Configuring the Interface Settings from the Settings Mode of the Product
Configure the settings related to the interfaces from the [Interface] menu, [Bluetooth] menu, or [Wi-Fi]
menu of the Settings mode of the product.
1. Tap [SETTINGS] on the Home screen or Offline screen.
2. Input the password if it is enabled.
3.
Tap [Interface], [Bluetooth], or [Wi-Fi]. The screen is switched by tapping / or
sliding the screen to the left or right.
To configure settings related to LAN/USB/NFC/RS-232C connections or CR/LF, CAN/DLE codes,
tap [Interface].
To configure settings related to Bluetooth, tap [Bluetooth].
To configure settings related to wireless LAN, tap [Wi-Fi].

SATO CT4-LX Specifications

General

Print Method	Thermal Transfer / Direct Thermal
Print Resolution	203 dpi
Max Print Width	4.09 inches (104 mm)
Media Type	Roll, Fan-fold
Media Thickness	0.0025 to 0.008 inches (0.0635 to 0.2032 mm)
Ribbon Width	0.98 inches (25 mm) to 4.09 inches (104 mm)
Ribbon Length	984 feet
Connectivity	USB, Ethernet, Bluetooth
Supported Barcode Types	PDF417, QR Code
Power Requirements	100-240 VAC, 50/60 Hz