NFC Interface Connection (Standard)
94
The USB interface is selected after connecting the USB cable to the computer and the product, and
powering on the product while the computer is turned on.
• If the product is powered on without installing the printer driver, Windows' Plug & Play
runs. When using the printer driver, do not power on the product while the USB cable is
connected until instructed in the procedure for installing the printer driver.
• We recommend a USB cable that is less than 5 m (16.4 feet) long.
NFC Interface Connection (Standard)
The NFC interface of the product supports a handover function that simplifies the Bluetooth/Wi-Fi
connection setup with Android devices.
The handover function only performs the connection setup, such as the pairing and authentication with
NFC, and passes the actual interface to the more advanced Bluetooth and Wi-Fi when communicating
between NFC supported devices.
In general, the pairing and authentication require some procedures to enter authentication information,
but the connection can be completed simply by holding the Android devices over the product while
using NFC.
Touch the NFC antenna (1) of the product with the NFC mark on the Android device.
To Next Page
Loading...
Need help?
General
