[Test Print]
256
The setting items are as follows:
[Media Profiles Registration]
Register print settings as media profiles for each type of media. You can register a maximum of 5
media profiles.
The setting items that can be registered to media profiles are as follows:
• [Printing] > [Media Type]
• [Printing] > [Printing Mode]
• [Printing] > [Speed]
• [Printing] > [Sensor Type]
• [Printing] > [Darkness]
• Setting items under [Printing] > [Advanced] > [Calibrate]
• Setting items under [Printing] > [Advanced] > [Label Waste Prevention]
• [Interface] > [RFID] > [RFID Tag Model] > [Load] (RFID models only)
To register a new profile, tap the items shown as [Non-registered]. To edit a registered media profile,
tap the items that show that profile's name. Do the settings according to the on-screen instructions.
Tap [Register] in the final confirmation screen to register the media profile.
An icon is added to the Home screen for the media profile that was registered. Tap the icon to apply
the settings to the product.
•
To cancel the settings, press the (Power/Home) button while you are doing the
settings, or tap [Cancel] in the final screen.
• If values that cannot be applied are included in the product settings at the time you are
trying to apply a media profile, those values are not reflected.
[Delete Media Profiles]
Delete a registered media profile.
Tap the media profile to delete, and then tap in the confirmation message.
Deleting a media profile also deletes the icon for the media profile that is displayed on the Home
screen.
[Test Print]
Perform a test print.
The setting items are as follows:
[Factory]
Perform the factory test print.
1. Check and set the items as listed on the [Factory] menu.
2.
Tap to start the test print. Tap to pause the print.
To Next Page
Loading...
