169
• The selectable operations differ according to the print mode.
Backfeed operationPrint Mode
None Before After
Continuous Possible - -
Tear-Off - Possible -
Dispenser Possible Possible Possible
Cutter Possible Possible Possible
Cut & Print - - Possible
Partial cutter Possible Possible -
Linerless cutter - Possible -
Linerless tearoff - Possible -
[Eject Cut]
In cut & print mode or backfeed before printing in partial cutter mode, set whether to do eject cut and
the standby time when doing eject cut.
Eject cut does not print the next data, and ends the print operation after cutting the last printed media.
Appears only if you have selected [Cut & Print] in the [Print Mode] menu or if you have selected
[Partial cutter] and then [Before] in [Backfeed].
The setting range is from 0 to 5 (sec). When set to 0, eject cut is not done.
[Darkness Range]
Display the range of the print darkness.
The darkness range affects the print darkness. The range is from A to F. The product is set to A.
[Darkness]
Specify the print darkness from 10 steps.
The setting range is from 1 to 10. 1 is the lightest and 10 is the darkest.
• The changes to this setting are linked and are changed with the settings in the [Tools] >
[Media Startup] menu.
• To further fine tune the print darkness, set [Printing] > [Advanced] > [Adjustments] >
[Darkness Adjust].
To Next Page
Loading...
Need help?
General
