245
[LCD Brightness]
Set the brightness of the screen.
The setting range is from 1 to 10.
1 is the darkest and 10 is the brightest.
• The product has a built-in energy saving function, which will decrease the brightness of
the screen when you have not operated the product for a period.
• You can set this item from the panel that is displayed by swiping the screen as well.
[Show Total Count]
Enable or disable the indication of the total print count.
If this is enabled, the total print count appears on both the Online and Offline screens.
The number in the brackets to the right of [QTY] on the Online and Offline screens is the total print
count.
• Shows the total print count from the time the product is turned on until it is off.
When you turn off the product, the count is reset to [0].
[Password]
The setting items are as follows:
[Password Enable]
Enable or disable the password setting.
If you have enabled the password input, you must enter the password set in the [Password] menu
before the [SETTINGS] menu will open.
• The default password is 0310. You can change the password in [Password] > [Change
Password] > [level1].
[Password Required After]
Set the period of time until password is required to enter the Settings mode again after once logging
in.
If you set it to 0, a password is required every time you enter the Settings mode or you select a
Settings menu item.
The setting range is from 0 to 99 minutes.
• The login status is maintained while the Settings mode or Home screen is displayed. If
you switch to the Online/Offline screen, you are logged out regardless of the [Password
Required After] setting.
To Next Page
Loading...
Need help?
General
