SATO CT4-LX User Manual

Printing RFID Tag Errors
396
Printing RFID Tag Errors
If the recorded data is incomplete, for some reasons such as writing to a defective tag, the product will
print an RFID tag error to the defective media. This function is to prevent the distribution of defective
media with a tag error.
When an RFID tag error occurs, the product prints a slash and the error message, such as "WRITE
TAG ERROR" or "TAG NOT FOUND". The position to print the message and slash is determined
according to the media size specified in the media size <A1> command.
For a write error such as "WRITE TAG ERROR", the product continues to print the first 16 or 32 bytes
of the write data.
The diagram below shows the message and slash printed on the position based on the media size
specified by the normal print.
WRITE TAG ERROR in RFID Write Command Read Error in UID/EPC/IDm Print specified
by the <TU> command or TAG NOT FOUND
Error
For other errors, the product prints the error
message accordingly.

SATO CT4-LX Specifications

General

Print Method	Thermal Transfer / Direct Thermal
Print Resolution	203 dpi
Max Print Width	4.09 inches (104 mm)
Media Type	Roll, Fan-fold
Media Thickness	0.0025 to 0.008 inches (0.0635 to 0.2032 mm)
Ribbon Width	0.98 inches (25 mm) to 4.09 inches (104 mm)
Ribbon Length	984 feet
Connectivity	USB, Ethernet, Bluetooth
Supported Barcode Types	PDF417, QR Code
Power Requirements	100-240 VAC, 50/60 Hz