Name: SATO CT4-LX
Brand: SATO
Rating: 4 (1 reviews)

To Next Page

To Previous Page

429

Setting Item Initial Value User Reset/

Factory Reset

[Enable] Enabled Yes

[Name] SATO

PRINTER_xxxxxxxxxxxx

(BD address)

Yes

[PIN Code] 0000 Yes

[BD Address] xxxxxxxxxxxx Yes

[Firm Version] - Yes

[Host BD Address] - Yes

[Pairing]

[Paired devices] - No

[IAP Ready] Enabled No

[iOS Reconnect] Disabled Yes

[Authentication] Level 4 Yes

[ISI] 2048 Yes

[ISW] 18 Yes

[PSI] 2048 Yes

[PSW] 18 Yes

[CRC Mode] Disabled Yes

[Flow Control] STATUS4 MULTI Yes

[Wi-Fi] Menu

The initial value refers to the setting value of the product when it was shipped from the factory. If you

reset the product, the setting values of the product will change back to the factory default values. The

table below shows the initial value of each setting item and type of reset that changes the value back

to the initial value.

• Normally, it is not necessary to perform the initialization. Doing an initialization removes

all the product's settings that the customer changed.

Setting Item Initial Value User Reset/

Factory

Reset

[Enable] Enabled Yes

Questions and Answers:

Need help?

Do you have a question about the SATO CT4-LX and is the answer not in the manual?

SATO CT4-LX Specifications

General

Print Method	Thermal Transfer / Direct Thermal
Print Resolution	203 dpi
Max Print Width	4.09 inches (104 mm)
Media Type	Roll, Fan-fold
Media Thickness	0.0025 to 0.008 inches (0.0635 to 0.2032 mm)
Ribbon Width	0.98 inches (25 mm) to 4.09 inches (104 mm)
Ribbon Length	984 feet
Connectivity	USB, Ethernet, Bluetooth
Supported Barcode Types	PDF417, QR Code
Power Requirements	100-240 VAC, 50/60 Hz