Operations in Linerless Cutter Mode
340
Operations in Linerless Cutter Mode
Linerless Cutter Mode and Backfeed After Printing (Head Check Disabled)
Operation
*1 The linerless sensor confirms the dispensing condition and the product does not perform the next
operation until the label is dispensed.
*2 The backfeed speed becomes 2 inches/sec immediately after powering on the product, or more
than 1 hour after completing a print operation or after completing a feed operation.
• The figure above shows the reference position when the I-mark sensor is used.
Timing Chart
To Next Page
Loading...
