SATO CT4-LX User Manual

Manually Setting the Print Mode
88
Manually Setting the Print Mode
You can change the print mode of the product according to product specification and its usage.
When [Auto-mode] is enabled, the print mode is set automatically according to the installed options.
You can manually set the print mode if you disable [Auto-mode]. The selectable print modes differ
according to the installed options.
Installed option Print mode
None Continuous/Tear-Off
Dispenser unit Continuous/Dispenser
Cutter unit Continuous/Tear-Off/Cutter/Cut & Print/Partial
cutter
Linerless cutter unit Linerless cutter/Linerless tearoff
Change the print mode according to the following procedure:
1. Tap [SETTINGS] on the Home screen or Offline screen.
2. Input the password if it is enabled.
3. Tap [Printing].

SATO CT4-LX Specifications

General

Print Method	Thermal Transfer / Direct Thermal
Print Resolution	203 dpi
Max Print Width	4.09 inches (104 mm)
Media Type	Roll, Fan-fold
Media Thickness	0.0025 to 0.008 inches (0.0635 to 0.2032 mm)
Ribbon Width	0.98 inches (25 mm) to 4.09 inches (104 mm)
Ribbon Length	984 feet
Connectivity	USB, Ethernet, Bluetooth
Supported Barcode Types	PDF417, QR Code
Power Requirements	100-240 VAC, 50/60 Hz