SATO CT4-LX User Manual

[Backfeed]
168
• The selectable print modes differ according to the installed options.
Installed option Print mode
None Continuous/Tear-Off
Dispenser unit Continuous/Dispenser
Cutter unit Continuous/Tear-Off/Cutter/Cut & Print/
Partial cutter
Linerless cutter unit Linerless cutter/Linerless tearoff
[Backfeed]
[Backfeed] is applicable only when the print mode is set to something other than continuous mode.
The options are as follows:
None
Does not backfeed.
After
After cut, backfeed the leading edge of the next media to the print head position.
For dispenser mode, backfeed the media to the leading edge of the next label after dispensing the
label.
Before
Before printing, backfeed the leading edge of the next media to the print head position.

SATO CT4-LX Specifications

General

Print Method	Thermal Transfer / Direct Thermal
Print Resolution	203 dpi
Max Print Width	4.09 inches (104 mm)
Media Type	Roll, Fan-fold
Media Thickness	0.0025 to 0.008 inches (0.0635 to 0.2032 mm)
Ribbon Width	0.98 inches (25 mm) to 4.09 inches (104 mm)
Ribbon Length	984 feet
Connectivity	USB, Ethernet, Bluetooth
Supported Barcode Types	PDF417, QR Code
Power Requirements	100-240 VAC, 50/60 Hz