SATO CT4-LX User Manual

Cleaning Intervals
434
Cleaning Intervals
Clean the product at the following regular intervals.
• The below cleaning intervals are only for reference. Clean the product when necessary
even if you are not at a regular interval.
• After every media roll or after printing 50 m (164.0 feet) of print media
Use a cotton swab or cotton cloth dampened with cleaning liquid to clean the following parts:
◦ Print head
◦ Platen roller
Use the cleaning kit to clean following parts:
◦ Media sensors
◦ Media guide
◦ Media route
• After every 6 media rolls or after printing 300 m (984.3 feet) of print media
Use the cleaning sheet to clean the following parts:
◦ Print head
Cleaning guidelines for when the optional linerless cutter kit is installed are as follows:
• After you print one media roll or whenever there is any glue residue or paper dust on the media
route
Use a cotton swab or cotton cloth dampened with cleaning liquid, and the cleaning kit to clean the
following parts:
◦ Linerless platen roller
◦ Print head
◦ Media guide
◦ Media sensors
◦ Media route

SATO CT4-LX Specifications

General

Print Method	Thermal Transfer / Direct Thermal
Print Resolution	203 dpi
Max Print Width	4.09 inches (104 mm)
Media Type	Roll, Fan-fold
Media Thickness	0.0025 to 0.008 inches (0.0635 to 0.2032 mm)
Ribbon Width	0.98 inches (25 mm) to 4.09 inches (104 mm)
Ribbon Length	984 feet
Connectivity	USB, Ethernet, Bluetooth
Supported Barcode Types	PDF417, QR Code
Power Requirements	100-240 VAC, 50/60 Hz