SATO CT4-LX User Manual

143
Registering Print Settings as Media Profiles (When Using Multiple Types
of Media)
When you are using multiple types of media, register print settings as media profiles for each type of
media. You can access the registered media profiles from the Home screen and apply them to the
product. You can easily switch the settings when replacing the media. You can register a maximum of
5 media profiles.
The setting items that can be registered to media profiles are as follows:
• [Printing] > [Media Type]
• [Printing] > [Printing Mode]
• [Printing] > [Speed]
• [Printing] > [Sensor Type]
• [Printing] > [Darkness]
• Setting items under [Printing] > [Advanced] > [Calibrate]
• Setting items under [Printing] > [Advanced] > [Label Waste Prevention]
• [Interface] > [RFID] > [RFID Tag Model] > [Load] (RFID models only)
1. Tap [SETTINGS] on the Home screen or Offline screen.
2. Input the password if it is enabled.
3. Tap [Tools].
You can switch the screen by tapping / or sliding the screen to the left or right.

SATO CT4-LX Specifications

General

Print Method	Thermal Transfer / Direct Thermal
Print Resolution	203 dpi
Max Print Width	4.09 inches (104 mm)
Media Type	Roll, Fan-fold
Media Thickness	0.0025 to 0.008 inches (0.0635 to 0.2032 mm)
Ribbon Width	0.98 inches (25 mm) to 4.09 inches (104 mm)
Ribbon Length	984 feet
Connectivity	USB, Ethernet, Bluetooth
Supported Barcode Types	PDF417, QR Code
Power Requirements	100-240 VAC, 50/60 Hz