247
manager
The password for accessing the [Service] menu.
Strictly for SATO authorized service personnel use.
level1
The password for accessing the [SETTINGS] menu.
rfid
This is the setting item for factory.
Appears only for the RFID models.
Strictly for SATO authorized service personnel use.
• Passwords other than [level1] are exclusively for factory and maintenance personnel.
You cannot change these passwords.
[Start on AC]
Set whether to power on/off the product by powering on/off the main power source.
Power on/off the product by powering on/off the main power source.
Power on/off the product by pressing the (Power/Home) button on the product.
• Do not repeatedly power on/off the product.
• If you power the main power source off and then on again quickly, the product may not
be powered on because it is still in the powering off process. In such a case, press the
(Power/Home) button to power on the product.
• Do not power off the product during operation, such as when printing or updating.
Doing so could cause a malfunction of the product.
• Do not disconnect the power cord until the powering off process is completed on the
product.
• An incorrect power on/off operation may damage the product settings. In such a case,
the product settings are reset to their initial values. It is always recommended to use
the power button to allow proper shutdown of the product and ensure changes made to
menu settings are saved appropriately.
[Compatible]
Set the compatible mode.
The setting items are as follows:
To Next Page
Loading...
Need help?
General
