SATO CT4-LX User Manual

Connecting the AC Adapter and the Power Cord
76
Powering On/Off the Product
Connecting the AC Adapter and the Power Cord
• Do not connect or disconnect the power cord while your hands are wet. Doing so could
cause an electric shock.
• Make sure that the AC voltage of your region is in the range of AC 100 - 240 V, 50 -
60 Hz. If your local voltage is not in the stated range, contact your SATO reseller or
technical support.
• The attached power cord and AC adapter are designed exclusively for this product. Do
not use them with other devices.
1. Connect the AC adapter and the power cord to the product.
a.
Connect the AC adapter (1) and the power cord (2) ( ).
b.
Insert the AC adapter plug (3) into the DC input connector at the rear of the product ( ).
c.
Insert the power plug into an AC outlet ( ).
• The shape of the power plug varies depending on the region in which it was
purchased.

SATO CT4-LX Specifications

General

Print Method	Thermal Transfer / Direct Thermal
Print Resolution	203 dpi
Max Print Width	4.09 inches (104 mm)
Media Type	Roll, Fan-fold
Media Thickness	0.0025 to 0.008 inches (0.0635 to 0.2032 mm)
Ribbon Width	0.98 inches (25 mm) to 4.09 inches (104 mm)
Ribbon Length	984 feet
Connectivity	USB, Ethernet, Bluetooth
Supported Barcode Types	PDF417, QR Code
Power Requirements	100-240 VAC, 50/60 Hz