427
Setting Item Initial Value User Reset/
Factory Reset
[Darkness Adjust] 50 No
[BD Address]
[Label Width] Large -
[Pitch] 0 dot No
[Offset] 0 dot No
[Darkness Adjust] 50 No
[HEX-Dump]
[Hex Dump Mode] Disabled Yes
[Reset] - -
[Profiles] - No
[Start with] - Yes
[Service]
[Factory]
[Wi-Fi Site Survey] - -
[Install Certificates] - Yes
[Delete Certificates] - Yes
[Clone] - -
[AutoClone Setting]
[Enable] Disabled Yes
[Startup Guide] Enabled No/Yes
[Information] Menu
The initial value refers to the setting value of the product when it was shipped from the factory. If you
reset the product, the setting values of the product will change back to the factory default values. The
table below shows the initial value of each setting item and type of reset that changes the value back
to the initial value.
• Normally, it is not necessary to perform the initialization. Doing an initialization removes
all the product's settings that the customer changed.
To Next Page
Loading...
