425
Setting Item Initial Value User Reset/
Factory Reset
[Wi-Fi]
[Wi-Fi Socket Cancel] Disabled Yes
[USB]
[Device ID] Disabled Yes
[RFID] Disabled Yes
[RS-232C]
[ENQ Reply] Disabled Yes
[Theme] Dark Yes
[Tools] Menu
The initial value refers to the setting value of the product when it was shipped from the factory. If you
reset the product, the setting values of the product will change back to the factory default values. The
table below shows the initial value of each setting item and type of reset that changes the value back
to the initial value.
• Normally, it is not necessary to perform the initialization. Doing an initialization removes
all the product's settings that the customer changed.
Setting Item Initial Value User Reset/
Factory Reset
[Media Startup] - -
[Media Profiles Editing] - -
[Media Profiles Registration]
[Media Profile 1] to [Media Profile 5] Non-registered No/Yes
[Delete Media Profiles]
[Media Profile 1] to [Media Profile 5] Non-registered No/Yes
[Test Print]
[Factory]
[Label Width] Large -
[Pitch] 0 dot No
[Offset] 0 dot No
[Darkness Adjust] 50 No
To Next Page
Loading...
