SATO CT4-LX User Manual

79
Powering Off the Product
• Do not connect or disconnect the power cord while your hands are wet. Doing so could
cause an electric shock.
• Do not power off the product during operation, such as when printing or updating.
Doing so could cause a malfunction of the product.
• Do not operate the product or disconnect the power cord while the product is powering
off.
• An incorrect power on/off operation may damage the product settings. In such a case,
the product settings are reset to their initial values. It is always recommended to use
the power button to allow proper shutdown of the product and ensure changes made to
menu settings are saved appropriately.
1. Before you power off the product, make sure that the product is in Offline mode.
If "Online" is displayed on the display, tap [OFFLINE] to switch to Offline mode.
2.
Press the (Power/Home) button (1) for more than 2 seconds.

SATO CT4-LX Specifications

General

Print Method	Thermal Transfer / Direct Thermal
Print Resolution	203 dpi
Max Print Width	4.09 inches (104 mm)
Media Type	Roll, Fan-fold
Media Thickness	0.0025 to 0.008 inches (0.0635 to 0.2032 mm)
Ribbon Width	0.98 inches (25 mm) to 4.09 inches (104 mm)
Ribbon Length	984 feet
Connectivity	USB, Ethernet, Bluetooth
Supported Barcode Types	PDF417, QR Code
Power Requirements	100-240 VAC, 50/60 Hz