SATO CT4-LX - [Interface] Menu

[Interface] Menu
410
[Interface] Menu
The initial value refers to the setting value of the product when it was shipped from the factory. If you
reset the product, the setting values of the product will change back to the factory default values. The
table below shows the initial value of each setting item and type of reset that changes the value back
to the initial value.
• [Network] > [Settings] > [LAN]
• [Network] > [Services] > [NTP]/[LPD]/[FTP]/[SNMP]
• [Network] > [Services] > [Online Services]
• [Network] > [Advanced]
• [RS-232C]/[USB]/[NFC]/[Ignore CR/LF]/[Ignore CAN/DLE]
• [RFID]
• Normally, it is not necessary to perform the initialization. Doing an initialization removes
all the product's settings that the customer changed.
• [Network] > [Settings] > [LAN]
Setting Item Initial Value User Reset/
Factory Reset
[IPv4 (LAN)]
[Mode] DHCP Yes
[DHCP] - -
[IP Address] 0.0.0.0 Yes
[Netmask] 255.255.255.0 Yes
[Gateway] 0.0.0.0 Yes
[DNS] 0.0.0.0, 0.0.0.0, 0.0.0.0 Yes
[IPv6 (LAN)]
[Mode] Disable Yes
[DHCP] - -
[IP Address] :: Yes
[Prefix Length] 64 Yes
[Gateway] :: Yes
[DNS] :: Yes
[Ports (LAN)]