SATO CT4-LX - Page 409

409
Setting Item Initial Value User Reset/
Factory Reset
[I-Mark Levels] Value adjusted by the
factory
No
[I-Mark Slice Level] Auto No
[Head Check] Off Yes
[Head Check Mode] Always Yes
[Every Page] 1 Yes
[Check Media Size] Disabled Yes
[Adjustments]
[Offset] 0 dot No
[Pitch] 0 dot No
[Darkness Adjust] 50 No
[Label Top Sensor] 0 dot No
[Start Online] Enabled Yes
[Feed After Error] Disabled Yes
[Feed At Power On] Disabled Yes
[Label Waste Prevention]
[Enable] Disabled Yes
[Registered Label Length]
203 dpi
3200 dots
305 dpi
4800 dots
Yes
[Finisher Feed] 0 dot (Standard) Yes
[Paper End] Using I-mark Yes
[Prioritize] Commands Yes
[Reprint] Disabled Yes
[Print End Position] 0 dot Yes