SATO CT4-LX - Page 408

[Printing] Menu
408
Setting Item Initial Value User Reset/
Factory Reset
[Print Mode]
If no option is installed
Tear-Off
If dispenser unit is
installed
Dispenser
If cutter unit is installed
Cutter
If linerless cutter unit is
installed
Linerless cutter
Yes
[Backfeed]
If [Print Mode] is set to
[Continuous]
None
If [Print Mode] is set to
[Tear-Off], [Cutter], [Partial
cutter], [Linerless cutter],
or [Linerless tearoff]
Before
If [Print Mode] is set to
[Dispenser] or [Cut & Print]
After
Yes
[Eject Cut] Off Yes
[Darkness Range] A Yes
[Darkness] 5 Yes
[Imaging]
[Vertical] 0 dot Yes
[Horizontal] 0 dot Yes
[Advanced]
[Calibrate]
[Auto-calibration] - -
[GAP Levels] Value adjusted by the
factory
No
[GAP Slice Level] Auto No