[Print Mode]
166
• If the optional linerless cutter unit is installed, the setting range is 2 to 4 ips.
• The changes to this setting are linked and are changed with the settings in the [Tools] >
[Media Startup] menu.
• Setting the print speed to a level that is too fast may affect the print quality.
[Sensor Type]
Set the sensor type for detecting the media.
The options are as follows:
None
Disable the media sensor.
Gap
Select when using the media of Gap type. Use the transmissive sensor.
I-Mark
Select when using the media of I-mark type. Use the reflective sensor.
• If you have selected [Dispenser] in the [Print Mode] menu, only [Gap] and [I-Mark] will
be available.
• If you have selected [Linerless cutter] or [Linerless tearoff] in the [Print Mode] menu,
only [None] and [I-Mark] will be available.
• Select something other than [None] to use the Label Waste Prevention function.
• Select something other than [None] to use RFID tags on an RFID model. If you set
[None], you cannot use RFID tags.
• The changes to this setting are linked and are changed with the settings in the [Tools] >
[Media Startup] menu.
[Auto-mode]
When [Auto-mode] is enabled, the print mode changes automatically according to the status of the
installed option.
Installed option Print mode that is set by Auto-mode
None Tear-Off
Dispenser unit Dispenser
Cutter unit Cutter
Linerless cutter unit Linerless cutter
[Print Mode]
Manually set the print mode.
To Next Page
Loading...
Need help?
General
