SATO CT4-LX User Manual

407
List of Initial Values
[Printing] Menu
The initial value refers to the setting value of the product when it was shipped from the factory. If you
reset the product, the setting values of the product will change back to the factory default values. The
table below shows the initial value of each setting item and type of reset that changes the value back
to the initial value.
• Normally, it is not necessary to perform the initialization. Doing an initialization removes
all the product's settings that the customer changed.
Setting Item Initial Value User Reset/
Factory Reset
[Media Type] Label Yes
[Label Length]
203 dpi
3200 dots
305 dpi
4800 dots
Yes
[Label Width]
203 dpi
832 dots
305 dpi
1248 dots
Yes
[Auto Measure] Disabled Yes
[Printing Mode] Use Ribbon Yes
[Ribbon Near End] Enabled Yes
[Speed] 4 ips Yes
[Sensor Type]
If [Print Mode] is set to
[Dispenser], [Tear-Off],
[Continuous], [Cutter], [Cut
& Print] or [Partial cutter]
Gap
If [Print Mode] is set
to [Linerless cutter] or
[Linerless tearoff]
None
Yes
[Auto-mode] Enabled Yes

SATO CT4-LX Specifications

General

Print Method	Thermal Transfer / Direct Thermal
Print Resolution	203 dpi
Max Print Width	4.09 inches (104 mm)
Media Type	Roll, Fan-fold
Media Thickness	0.0025 to 0.008 inches (0.0635 to 0.2032 mm)
Ribbon Width	0.98 inches (25 mm) to 4.09 inches (104 mm)
Ribbon Length	984 feet
Connectivity	USB, Ethernet, Bluetooth
Supported Barcode Types	PDF417, QR Code
Power Requirements	100-240 VAC, 50/60 Hz