[RFID]
208
Returns the factory set USB serial number (unique to each product).
This option is suitable when you want to set the printer driver for each product.
• If two products that have the same USB serial number connected to the same
computer, it may cause the computer to show a blue screen error.
[NFC]
Sets the NFC connection.
The setting items are as follows:
I/F Enable
Enables or disables the NFC interface.
[Ignore CR/LF]
Set whether to ignore the CR/LF code (0x0D / 0x0A) in the received data.
[Ignore CAN/DLE]
Set whether to ignore the CAN/DLE code (0x18 / 0x10) in the received data.
• A message prompting you to restart the product will appear on the Home screen if you
have made any changes. In such a case, reboot the product to apply the settings.
[RFID]
Set the RFID.
Appears only for the RFID models.
The setting items are as follows:
[Antenna Position]
Follow the Inlay Configuration Guide to select an RFID antenna to use. For details, access the
following URL:
https://www.sato-global.com/rfid/guide.html
To use inlays that are not in the Inlay Configuration Guide, contact your SATO sales representative or
reseller.
The options are as follows:
To Next Page
Loading...
