SATO CT4-LX - Page 154

Media Sensor Type
154
4. Tap [Sensor Type].
5. Tap the sensor type to detect the print position.
[None]
Disable the media sensor.
[Gap]
Select when using the media of Gap type. Use the transmissive sensor.
[I-Mark]
Select when using the media of I-mark type. Use the reflective sensor.
• If you have selected [Dispenser] in the [Print Mode] menu, only [Gap] and [I-Mark] will
be available.
• If you have selected [Linerless cutter] or [Linerless tearoff] in the [Print Mode] menu,
only [None] and [I-Mark] will be available.
• Select something other than [None] to use the Label Waste Prevention function.
• Select something other than [None] to use RFID tags on an RFID model. If you set
[None], you cannot use RFID tags.