171
Horizontal
Set the print position in the horizontal direction.
Set the correction value from the print reference position when facing the product as "-" to adjust
to the right side and "+" to adjust to the left side.
(1) Feed direction
The setting range varies depending on the print resolution of the product.
The setting range is as follows:
Resolution Setting range
203 dpi (1 dot = 0.125 mm (0.0049")) -831 to +831 dots
305 dpi (1 dot = 0.083 mm (0.0033")) -1247 to +1247 dots
• You can change the units to dots, " (inches), or mm in the [System] > [Regional] >
[Unit] menu.
To Next Page
Loading...
