SATO CT4-LX - Page 258

[Test Print]
258
[Configure List]
Print the product setting information.
1. Check and set the items as listed on the [Configure List] menu.
2.
Tap to start the test print. Tap to pause printing.
To stop the test print, pause printing, and then tap .
The setting items are as follows:
Category
Select the category of the list to print.
The options are as follows:
◦ [All]
◦ [Information]
◦ [Printing]
◦ [Interface]
◦ [Applications]
◦ [System]
Label Width
Shows the necessary media width of the test print.
The necessary media width is 50.8 mm (2") for [Small].
Label Length
Set the length of one piece of the media used for the test print.
The setting range varies depending on the print resolution of the product.
The setting range is as follows:
Resolution Setting range
203 dpi (1 dot = 0.125 mm (0.0049")) 400 to 1,600 dots
305 dpi (1 dot = 0.083 mm (0.0033")) 600 to 2,400 dots
Pitch
Set the print position in the vertical direction.
The setting range varies depending on the print resolution of the product.
The setting range is as follows:
Resolution Setting range
203 dpi (1 dot = 0.125 mm (0.0049")) -30 to +30 dots