476
Cause and Countermeasure Reference
• The command error appears when [Show
Error] in [SBPL] under the [Applications]
menu is set to [Enabled].
Contact your SATO technical support if the error cannot be resolved.
Contact Information for When You Are in Trouble
How to See the Command Error Information
• Location of error occurrence
"Caaa" in the command error message shows the location of command error.
The number of ESC commands from start code <A> command is shown in "aaa".
Note that the start code <A> command is not included in the number of ESC commands, which
can be shown up to 999.
When a command error is detected by the Horizontal Print Position <H> command.
------: [ESC]A
C001: [ESC]V100
C002: [ESC]H99999
C003: [ESC]L0202
C004: [ESC]M,ABCDEF
C005: [ESC]Q1
C006: [ESC]Z
In this case, C002 is the location of the error.
• Error command name
The command name is shown in "<bb>". Error is detected in the command name.
◦ A one-byte command name is left aligned
• Error description
The cause of command error appears in "cc" in the error message ("Caaa:<bb>:cc").
Description ("cc") Cause
Invalid command Analyzed improper command.
Invalid parameter Received improper parameter.
Command table read
error
Failed to read the command table.
Invalid graphic data/
custom designed data
Analyzed improper graphic and custom designed data.
To Next Page
Loading...
